About The Pot Buddy XL

A tremendously useful breadboarding companion.

Instead of stretching and blowing out the springs within your breadboard with thick pot pins or having to pluck out your pot just to get a read on where it's set, grab a Pot Buddy XL and then jumper your pots into place.  

Connect your multimeter to the loop hookups at the left of the board and simply flip a toggle switch to get a quick read on any of your pots.

The Pot Buddy XL makes room for up to six typical 16mm potentiometers.

Finally, if you need more than six pots for a project, you can daisy chain multiple Pot Buddy XL's (or Trim Buddy XL's for that matter) to each other using a three wire JST PH (2.0mm) cable. This will allow your connected multimeter to read any of the daisy chained pots without having to move it from board to board.