Quickly run through hundreds of parts when you're sorting your parts or hunting for precise value matches. This little jig 'breaks-out' the test leads of any multimeter into an ergonomic, speed testing configuration. Drop any axial part into the component seat and flop the pressure hinge down to shore up the contact. READ MORE...

Less than perfect, but still entirely useful. FREE prototypes, B stock, and functional defects. At worst the products listed here will be slightly impacted by a design defect, but still entirely useful. At best they'll just be left over stock of an older product which has been replaced by a newer version. READ MORE...

Instead of stretching the springs of your breadboard with thick pot pins or plucking out your pot just to get a read on where it's set, grab a Pot Buddy XL and jumper your pots into place. Connect your multimeter to the loop hookups of the board & simply flip a toggle switch to get a quick read on any of your pots. READ MORE...

As far as I can tell, there's just no good 'out-of-the-box' way to breadboard with dual gang pots. This tool sets out to address this by extending all the same smart features of the Pot Buddy XL to 9mm dual gang pots. READ MORE...

Skip fumbling with resistors or stalling your project when you don't have the right values on hand. Just seat a 3362P trimpot in your TRIMSPOT and pop it on your breadboard. Dial in any resistance and get a quick read at your multimeter (without removing your trimpot) when you need it with just the flick of a switch. READ MORE...

Jump the rails! Pop a Hobo onto the end of your breadboard to neatly tie your 'like' rails together across your breadboard. This comes pre-soldered, ready to go, no assembly required. READ MORE...