Trim Buddy XL
Related Items
-
3296-type Trimpot Adjustment ToolOut of stock
-
EXTRASOut of stock
-
Head up!
The Trim Buddy XL is BYOT (bring your own trimmers). It does NOT include trimmers. You may want to ADD a few to your cart from above
About The Trim Buddy XL
A tremendously useful breadboarding companion.
Instead of fumbling with fixed resistors while breadboarding, grab a Trim Buddy XL so you can just dial in your resistances using 3296W style trimpots and then jumper them wherever you'd have stuck your resistor legs.
Connect your multimeter to the loop hookups at the left of the board and simply flip a toggle switch to get a quick read on any of your trimpots.
The Trim Buddy XL offers up to six adjustable resistances.
Finally, if you need more than six resistances for a project, you can daisy chain multiple Trim Buddy XL's to each other using a three wire JST PH (2.0mm) cable. This will allow your connected multimeter to read any of the daisy chained trimpots without having to move it from board to board.
You might also dig...
-
![Common Emitter Explorer Board Kit [v2]](https://cdn.shopify.com/s/files/1/0572/8976/9073/files/full-spread-1_93a047c0-5554-478a-b1f4-9e19a434eee9.jpg?v=1771509033&width=500)
Common Emitter Explorer Board Kit [v2]
Common Emitter Explorer Board v2 is an unassembled learning board kit for a beta-independent, common emitter amplifier. Drop in any BJT transistor and start exploring. Grab your multimeter and probe the test points while adjusting the timpots to explore again and again. READ MORE...$12-$34 USD BUY/DETAILS ⮕ -
Pot Buddy XL
Instead of stretching the springs of your breadboard with thick pot pins or plucking out your pot just to get a read on where it's set, grab a Pot Buddy XL and jumper your pots into place. Connect your multimeter to the loop hookups of the board & simply flip a toggle switch to get a quick read on any of your pots. READ MORE...$8-$46 USD BUY/DETAILS ⮕ -
Breadboard Breakout - TrimSpot 3362P
Skip fumbling with resistors or stalling your project when you don't have the right values on hand. Just seat a 3362P trimpot in your TRIMSPOT and pop it on your breadboard. Dial in any resistance and get a quick read at your multimeter (without removing your trimpot) when you need it with just the flick of a switch. READ MORE...$2-$7.50 USD BUY/DETAILS ⮕ -
Breadboard Hobo
Jump the rails! Pop a Hobo onto the end of your breadboard to neatly tie your 'like' rails together across your breadboard. This comes pre-soldered, ready to go, no assembly required. READ MORE...$5 USD BUY/DETAILS ⮕