The Brother
Related Items
-
EXTRASOut of stock
-
Breadboard HoboOut of stock
-
Breadboard Breakout - Switch DP3TOut of stock
-
Breadboard Breakout - Switch DPDTOut of stock
-
Breadboard Breakout - TrimSpot 3362POut of stock
-
Breadboard Breakout - TrimSpot 3386POut of stock
-
PDF Guidebook
-
What's included...
The Brother comes entirely pre-soldered, though you will need a screwdriver to attach the optional 9V battery holder and angled risers (if you want to use them).
The Brother also includes a JST PH to pin cable assembly (for use with the built-in Probe Caddy) and a JST XH to 9V battery clip cable assembly.
About The Brother
All of the comforts offered by The Mother, without some of the fancy indulgences of The Breadboard Butler.
The Brother (which comes pre-soldered and ready to rock), is a breadboarding platform that makes swapping projects as easy as changing sheets of paper in a three ring binder. And unlike The Mother (which requires a separate breadboarding module for I/O), The Brother sports all the core features you need as well as a few extra bells and whistles built-in.
Stereo I/O, switched DC barrel jack and 9V battery clip, signal bypass switch, quick-release spring clips, angled risers, and a built-in Probe Caddy!
Patch the LEFT and RIGHT sockets that flank the breadboard loading zone to feed your breadboard and off you go.
When you're done with your breadboard project, or when you need to switch to something new, mid-project, instead of ripping it up to clear your breadboard, just disconnect the patches from the LEFT/RIGHT sockets, release the little spring clips, and lift off your breadboard (parts still inserted) to replace it with a fresh one.
You might also dig...
-
Multimeter Breakout
Quickly run through hundreds of parts when you're sorting your parts or hunting for precise value matches. This little jig 'breaks-out' the test leads of any multimeter into an ergonomic, speed testing configuration. Drop any axial part into the component seat and flop the pressure hinge down to shore up the contact. READ MORE...$32 USD BUY/DETAILS ⮕ -
Bottom-up Bench Rest for Hammond-style Enclosures
Need access to your pedal's innards? If it's in a Hammond Mfg. style enclosure then these configurable magnetic risers will help you get the job done. Avoid scratches on the finish and secure an assembled pedal without precariously resting it all on it's own surface knobs/controls. READ MORE...$16-$20 USD BUY/DETAILS ⮕ -
Dual Gang 9mm Pot Buddy XL
As far as I can tell, there's just no good 'out-of-the-box' way to breadboard with dual gang pots. This tool sets out to address this by extending all the same smart features of the Pot Buddy XL to 9mm dual gang pots. READ MORE...$8-$46 USD BUY/DETAILS ⮕ -
Earrings "Without a trace"
When life gives you lemons, make... earrings? After realizing the a mistake I made with a batch of failed PCBs I took to reddit to share my blunder and have a laugh at my own expense. Wasn't long before someone suggested I turn these little lemons into earrings. Long story short - now I sell jewelry. READ MORE...$9 USD BUY/DETAILS ⮕